H3C Technologies H3C Intelligent Management Center - Manual (Page 386)

364
1. Click the Service tab.
2. From the navigation tree, select WLAN Manager > View Management > Location Views.
The Location List displays all location views.
3. Click the Delete icon for the location view.
A confirmation dialog box appears.
4. Click OK.
Adding a sub-location view
This function helps you adds sub-location views to a location view or a sub-location view. You cannot
add sub-location views to the location view associated with a hotspot.
To add a sub-location view:
1. Click the Service tab.
2. From the navigation tree, select WLAN Manager > View Management > Location Views.
The Location List displays all location views.
3. Continue the procedure in one of the following ways:
{
Click the name of the target location view.
The Sub-location/Device List page appears.
{
On the Sub-location/Device List page, click the name of the target sublocation view.
The Sub-location/Device List page appears.
4. Click More and select Add Sub-location .
The Add Location page appears.
5. Set the following parameters as needed:
{
Location Name—Enter a name to uniquely identify the sub-location view.
{
Location Type—Select a location type for the sub-location view. Options are:
− Area
− Building
− Floor
− Room
The options vary by the location type.
{
Hotspot—Set whether the sub-location view is a GIS hotspot. The hotspot manages all APs
belonging to it. It cannot contain any sub-location views. Sub-location views can be added
only to the location views with no hotspot associated.
You must configure extended properties that have been defined for the hotspot. For more
information, see "
Configuring extended properties for hotspots associated with location
views ."
{
Automatically Add AP—Select this option to automatically add an AP to the sub-location
view.
You must configure an AP matching rule:
− Start IP Address/End IP Address—Enter the IP address range for the AP. The start IP
address and the end IP address must be in the same format.