H3C Technologies H3C Intelligent Management Center - Manual (Page 473)

451
{
Matching Relations—Matching relations for each item. Options are AND and OR.
The area below displays the match items and their values. If a match item is not enabled,
the value is displayed as None.
Match Frame Type
− Frame type—Options are Control Frame, Management Frame, and Data Frame.
− Match Frame Sub Type—Options are None, Dis-association, Probe Request, Beacon,
Association Response, De-authentication, Association Request, and Authentication.
When you select None, WIPS does not match any frame sub type.
An 802.11 frame is considered as matching this item if it matches the predefined values.
Match MAC Address
− MAC address.
− Match MAC Address Type—Options are Source Address, Destination Address, and
BSSID.
An 802.11 frame is considered as matching this item if it matches the predefined values.
Match Packet Sequence Number
− Match Criteria—Options are Greater than, Smaller than, Between, and Equal to.
− Start Value—This field is displayed when the match criteria is Greater than or Between.
− End Value—This field is displayed when the match criteria is Smaller than or Between.
− Value—This field is displayed when the match criteria is Equal to.
An 802.11 frame is considered as matching this item if it matches the predefined values.
Match SSID Length
− Match Criteria—Options are Greater than, Smaller than, Between, and Equal to.
− Start Value—This field is displayed when the match criteria is Greater than or Between.
− End Value—This field is displayed when the match criteria is Smaller than or Between.
− Value—This field is displayed when the match criteria is Equal to.
An 802.11 frame is considered as matching this item if it matches the predefined values.
Match SSID
− Match Criteria—Options are Greater than, Smaller than, Between, and Equal to.
− Value.
− Case Sensitive—Options are Yes and No.
An 802.11 frame is considered as matching this item if it matches the predefined values.
6. Click Back.
Querying signature rules
To perform a basic query:
1. Click the Service tab.
2. Select WLAN Manager > WIPS Management > Virtual Security Domain from the navigation tree.
3. Click the Signature Policy tab.
4. Click Signature Rule.
The signature rule list displays all signature rules.