H3C Technologies H3C Intelligent Management Center - Manual (Page 257)

235
Operators can view the mesh peer MAC address of the neighbor of the current radio in the
Peer MAC Address List.
5. Click Back to go back to the Device Details page.
Adding a mesh peer MAC address
You can configure a maximum of eight mesh peer MAC addresses for a radio.
To add a mesh peer MAC address:
1. Click the Service tab.
2. From the navigation tree, select WLAN Manager > Resource Management > Fat APs.
The Fat AP List page displays all fat APs.
3. Click the device label of the target fat AP.
4. In the Radio Information area on the Wireless Service Information tab, click the Configure Mesh
Peer MAC Address icon
of the target radio to enter the page for configuring mesh peer
MAC addresses.
5. In the Peer MAC Address box, enter a mesh peer MAC address, in this format:
hh:hh:hh:hh:hh:hh.
6. Click Add.
7. Click Back to go back to the Device Details page.
Deleting a mesh peer MAC address
1. Click the Service tab.
2. From the navigation tree, select WLAN Manager > Resource Management > Fat APs.
The Fat AP List page displays all fat APs.
3. Click the device label of the target fat AP.
4. In the Radio Information area on the Wireless Service Information tab, click the Configure Mesh
Peer MAC Address icon
of the target radio to enter the page for configuring mesh peer
MAC addresses.
5. Select one or more MAC addresses from the Peer MAC Address List, and click Delete.
A confirmation dialog box appears.
6. Click OK.
7. Click Back to go back to the details page of the fat AP.
Configuring 802.11 rates
This feature allows you to modify the supported rates, mandatory rates, and disabled rates for
802.11a, 802.11b, and 802.11g radios.
To configure 802.11 rates:
1. Click the Service tab.
2. From the navigation tree, select WLAN Manager > Resource Management > Fat APs.
The Fat AP List page displays all fat APs.