H3C Technologies H3C Intelligent Management Center - Manual (Page 592)

570
{
Link Keep Alive Interval—Interval for sending keepalives, in seconds. If an AP has not
received a response from its peer AP after three attempts of sending keepalives, the mesh
link disconnects.
{
Link Backhaul Rate—Backhaul rate of the mesh link. The value varies with radio types, and
must be the same in one mesh network.
{
Enable Mesh Profile—Indicates whether the mesh profile is enabled. A mesh profile can be
enabled only when it is bound to a mesh interface with port security configured.
{
Enable MKD Service—Indicates whether the MKD service for the mesh profile is enabled. It is
supported on ACs only.
{
Operation—Click the Operation icon to modify or delete a mesh profile and to view
radios bound to the mesh profile.
On the Mesh Profile Management page of an AC, radios to be bound to a mesh profile are
displayed.
Radio List contents
{
Admin Status—Administrative state for the radio. Options are Up and Down.
{
Radio ID—ID of the radio.
{
AP Template Name—Name of the template used by the AP to which the radio belongs.
{
Radio Type—Select a type of the radio from the list. Options are:
− 802.11a
− 802.11b
− 802.11g
− 802.11gn
− 802.11an.
{
Mesh Profile ID—ID of the mesh profile to which the radio has been bound. This field
displays 0 if the radio has not been bound to any mesh profile.
{
Delete—Click the Delete icon to delete a radio that is not required to be bound to a mesh
profile.
On the Mesh Profile Management page of a fat AP, all radios of the fat AP are displayed.
Radio Information contents
{
Interface—Radio interface to be bound to a mesh profile. Click the interface link to enter the
fat AP radio details page.
{
Radio Type—Select a type of the radio from the list. Option are:
− 802.11a
− 802.11b
− 802.11g
− 802.11bg
− 802.11at
− 802.11an
− 802.11gn
− 802.11n (2.4GHz)
− 802.11bgn
− 802.11n