H3C Technologies H3C Intelligent Management Center - Manual (Page 641)

619
• Begin Time/End Time—These two parameters appear only when you select Custom Range. Click
the field next to Begin Time/End Time to select the start time/end time from the calendar that
appears, in the format of YYYY-MM-DD hh:mm. The end time must be later than the start time.
Figure 84 shows an example AC statistics report.
Figure 84 AC statistics report
AC statistics report fields:
• Report Period—Time range during which the statistics were collected.
• AC Name—Name of the AC.
• IP Address—IPv4 address of the AC.
• AP Number—Total number of APs managed by the AC.
• Online/M APs—Number of master APs managed by the AC.
• Online/B APs—Number of backup online APs managed by the AC.
• Availability (%)—Percentage of time the APs managed the AC are available.
• Busy APs—Number of busy APs managed by the AC. An AP is considered busy when its
associated client number or transmission rate reaches the specified threshold. For more
information, see "
Busy AP statistics report ."
• Idle APs—Number of idle APs managed by the AC. An AP is considered idle when its
associated client number or transmission rate is equal to or below the specified threshold. For
information about, see " Idle AP statistics report ."
• Worst APs—Number of worst APs managed by the AC. An AP is considered as worst when its
out of service rate or association congestion rate reaches the specified threshold.
• Transmitted Traffic (MB)—Total traffic transmitted by the AC.