H3C Technologies H3C Intelligent Management Center - Manual (Page 519)

497
Viewing the signal coverage of virtual APs
After automatic network planning, you can view the signal coverage of virtual APs and adjust AP
numbers or AP locations based on the coverage. To view signal coverage, see "
Displaying a signal
coverage area map " and " Setting colors ."
Deploying virtual APs
You can adjust AP deployment based on the signal coverage.
Adding a virtual AP to the current location
After you enable the automatic network planning function, you can add one or more virtual APs
manually to a location to complete signal deployment.
To add a virtual AP to the current location:
1. Right-click on a blank area, and from the shortcut menu, select Adding virtual APs to this
location.
The Select AP Model window appears.
2. Select an AP model, and click OK.
You return to the location view, and enter adding virtual AP mode.
3. Click on a spot where the virtual AP is to be added.
The added virtual AP appears on the spot.
4. Press the ESC key to exit adding virtual AP mode.
Modifying a virtual AP
1. Right-click the virtual AP to be modified, and from the shortcut menu, select Modify Virtual AP.
2. Enter a new AP label in the AP Label field.
3. Modify the radio configuration.
One or more radio configuration tabs might appear, depending on the virtual AP model. The
configuration methods are the same for all radios. This example modifies the parameters of
Radio 1.
{
Model—Cannot be modified.
{
Enable—Enable or disable the radio.
{
Radio Type—Select a radio type from the following:
− 802.11a
− 802.11b
− 802.11g
− 802.11an
− 802.11gn
{
Channel—Select the channel where the radio is operating.
{
Power(dBm)—Enter the radio power, in dBm.