H3C Technologies H3C Intelligent Management Center - Manual (Page 79)

57
Configuring group parameters
WSM enables you to configure radio parameters in a group by AP model. After you configure this
feature, the radios of a fit AP will inherit parameters of the group to which the fit AP belongs.
To configure parameters for a group on an AC:
1. Click the Service tab.
From the navigation tree, select WLAN Manager > Resource Management > ACs. The AC List
page displays all ACs.
2. Click the Operation icon for an AC.
3. Select Group Configuration from the menu.
The Group List displays all fit AP groups on the AC.
4. Click the Group Parameter Config icon for the group you want to configure.
The AP Model List displays all the AP models supported on the AC.
5. Click the AP model for which you want to configure radio parameters.
6. Click the box next to the Inherited field located on the top right corner of the page to inherit the
AP global parameters of the AC, and then go to step 7.
Or
Clear the Inherited box and manually configure the radio parameters for the fit AP model.
The radio parameters vary with the operating mode:
• For a radio with an operating mode of Monitor, the Max Transmission Power, Admin Status,
Scan Ratio, and Bands to scan parameters do not appear.
• For a radio with an operating mode of Sensor, only the Description field appears.
• For a radio with an operating mode of Access point and Local mesh or Local mesh only, the
Neighborhood scanning parameters do not appear.
{
Radio Type—Select a radio type. Available options depend on the country code and the AP
model.
{
Max Transmission Power—Enter the maximum transmission power of the antenna. The value
range varies by device model. For more information, see the device manual.
{
Admin Status—Select an administrative state for the radio. Options are Up and Down.
{
Channels in Use—Select the working channel of the radio. The value range depends on the
radio type. If you select Auto, a fit AP selects an idle channel as the working channel.
{
Operating Mode—Select the operating mode as follows:
− Access Point and Local Mesh—Standard operating mode provides support for all wireless
functions.
− Access Point Only—Only provides access point functionality. Local mesh links cannot be
created.
− Local Mesh Only—Only provides local mesh functionality. Wireless client stations cannot
connect.
− Monitor—Disables access point and local mesh functions.
− Sensor—Only monitors the wireless signals in the surrounding environment. Use this
option for continuous scanning across all channels in all supported wireless modes.
{
Description—Enter a description for the radio.