H3C Technologies H3C Intelligent Management Center - Manual (Page 205)

183
− 802.11n(5GHz)
{
Channels in Use—Select the working channel of the radio. The value range depends on the
radio type. If you select Auto, the fat AP evaluates the channel quality and selects an
optimum channel as the working channel.
{
Admin Status—Select an administrative state for the radio. Options are Up and Down.
Radios in Down state do not transmit wireless signals.
{
Transmission Power—Enter the maximum transmission power of the radio. The value range
depends on the device model.
{
Operating Mode—Select the operating mode of the radio. These are the operating mode
options:
− Access Point and Local Mesh
− Access Point Only
− Local Mesh Only
− Monitor
− Sensor
The value range depends on the device model.
{
Description—Enter a description for the radio.
6. In the Selected Radios area, select the radios you want to configure. Options are All Radios and
Selected Radios.
{
All Radios—Select this option to configure all radios. Then go to step 12.
{
Selected Radios—Select this option to configure only the selected radios.
If the Selected Radios option is selected, the page refreshes to displays the Radio List area.
7. In the Radio List area, click Add to display the Select Radio dialog box.
8. Enter or select one or more of the following query criteria to search for the radios you want to
configure:
{
AP Label—Enter the label of the fat AP to which the radio belongs. WSM supports fuzzy
matching for this field
{
IP Address—Enter the IPv4 address of the fat AP. WSM supports fuzzy matching for this field.
{
Model—Enter the model of the fat AP to which the radio belongs. WSM supports fuzzy
matching for this field.
{
Radio Type—Select a radio type. These are the radio type options:
− All
− 802.11a
− 802.11b
− 802.11g
− 802.11bg
− 802.11at
− 802.11an
− 802.11gn
− 802.11n (2.4GHz)
− 802.11bgn
− 802.11n