H3C Technologies H3C Intelligent Management Center - Manual (Page 620)

598
Items Description
60%, and six APs whose high-rate outgoing packet ratio has exceeded
80%, part 1 makes up 6/10 and part 2 makes up 4/10 of the pie chart.
Part I (%) > =
Set the high-rate outgoing packets ratio for APs in part 1, in the range of 0
to 100.
By default, the value is 80%.
APs whose high-rate outgoing packets ratio exceeds the value belong to
part 1.
Part II (%) > =
Set the high-rate outgoing packets ratio for APs in part 2, in the range of 0
to 100, which must be smaller than the value of part 1.
By default, the value is 60%.
APs whose high-rate outgoing packets ratio exceeds the value and is
smaller than the value of part 1 belong to part 2.
Part III (%) > =
Set the high-rate outgoing packets ratio for APs in part 3, in the range of 0
to 100, which must be smaller than the value of part 2.
By default, the value is 40%.
APs whose high-rate outgoing packets ratio exceeds the value and is
smaller than the value of part 2 belong to part 3.
Part IV (%) > =
Set the high-rate outgoing packets ratio for APs in part 4, in the range of 0
to 100, which must be smaller than the value of part 3.
By default, the value is 20%.
APs whose high-rate outgoing packets ratio exceeds the value and is
smaller than the value of part 3 belong to part 4.
Part V (%) > = APs that do not belong to the former four parts belong to part 5.
c. Click OK.
8. Click Restore the Defaults to restore the global thresholds to default thresholds.
9. Click Back to return to the Task List page.
Setting thresholds for an evaluation task
By default, an evaluation task uses global thresholds until you set thresholds for the evaluation task.
This function takes effect only for the current evaluation task, and it does not take effect on an
evaluation task in Evaluating state.
To set thresholds for an evaluation task:
1. Click the Service tab.
2. From the navigation tree, select WLAN Manager > Network Evaluation. The Task List page
displays all evaluation tasks.
3. Click the Threshold Settings icon for the target evaluation task.
4. Click the Setting link for an index type and set the thresholds for the index in the window that
appears. For more information, see "
Setting global thresholds ."