H3C Technologies H3C Intelligent Management Center - Manual (Page 497)

475
{
Type—Type of the device against which countermeasures will be taken. Options are Static,
Dynamic, and Static and Dynamic.
− Static—The device is in the static countermeasures address list, but has not been detected
by the sensor.
− Dynamic—The device has been detected by the sensor, and WIPS will take
countermeasures against the device.
− Static and Dynamic—The device is in the static countermeasures address list and has
been detected by the sensor. WIPS will take countermeasures against the device.
{
Status—Current state of the device. Options are Countermeasure, Idle, and Pending.
− Countermeasure—Countermeasures have been taken against the device.
− Idle—The device is manually added to the countermeasures address list, but the sensor
has not detected the device.
− Pending—Device against which WIPS will take countermeasures.
{
Start Time—Time when WIPS took countermeasures against the device for the first time.
{
Category—Category of the device.
{
Channel—Channel where the device is operating. The sensor takes countermeasures against
the device on this channel.
{
Countermeasure Priority—Countermeasure priority for the device. It is determined by the
countermeasure policy. This field is empty when the Category field is empty.
{
AC—For a Static device, this column displays the device label for the AC that the device is
associated. For a Dynamic device, this column displays the device label for the AC with
which the sensor that has detected the device is associated. Click the label link to enter the
AC management page.
If the Countermeasures Address List contains enough entries, the following navigational aids
appear:
{
Click to page forward in the Countermeasures Address List.
{
Click to page forward to the end of the Countermeasures Address List.
{
Click to page backward in the Countermeasures Address List.
{
Click to page backward to the front of the Countermeasures Address List.
4. Click 8, 15, 50, 100, or 200 on the right side of the main pane to specify the number of items
you want to display on each page.
NOTE:
You can sort the Countermeasures Address List by all fields. Click the column label to sort the list by the
selected field. The column label allows you to toggle between the various sort options specific to each
field.
Synchronizing countermeasures addresses
By default, IMC synchronizes the static countermeasures address list from managed ACs every 2 hours.
You can also manually perform the synchronization operation.
To manually synchronize the static countermeasures address list from managed ACs:
1. Click the Service tab.