H3C Technologies H3C Intelligent Management Center - Manual (Page 179)

157
{
Device Label—Label of the AC.
{
SSID—SSID of the WLAN.
{
Profile Name—Profile name of the WLAN.
{
Result—Operation result for deleting WLANs. If the operation fails, WSM provides the cause
of failure. You can modify the configuration to delete WLANs again.
9. Click Back to go back to the Batch Create WLANs page.
Batch configuring radios
1. Click the Service tab.
2. From the navigation tree, select WLAN Manager > Configuration Management.
The Configuration Management page appears.
3. Click the Cisco tab.
4. In the Configuration Management area, click Radio Batch Configuration.
The Radio Batch Configuration page appears.
5. Configure the basic Information:
a. Select Basic Information.
b. Admin Status—Select an administrative state for the radio. Options are Up and Down. A
radio can operate only when both of its administrative and operating states are Up.
6. Configure the antenna:
a. Select Antenna Config.
b. Antenna—Enable the specified ports on the antenna.
− A—The left port of the antenna
− B—The right port of the antenna
− C—The center port of the antenna
7. Assign a channel:
Radio channels can be assigned in a global or custom way.
a. Select Channel Assignment.
b. Assignment method—Select a channel assignment method. Options are Global and Custom.
− Global—The AC assigns a channel globally. You need to log in to the AC to configure
this option. For more information, see the configuration guide of the AC.
− Custom—Manually specify a working channel. The working channel of the radio does
not change unless you manually specify a new channel. Available channels are
determined by the country code of the AP.
8. Configure a Tx power level assignment method:
The Tx power level can be assigned globally or user defined.
a. Select Tx Power Level Assignment.
b. Assignment Method—Select a Tx power level assignment method. Options are Global and
Custom.
− Global—The AC assigns a transmission power level globally. You need to log in to the
AC to configure this option. For more information, see the configuration guide of the AP.