H3C Technologies H3C Intelligent Management Center User Manual
Page 598
576
{
Enable Link Initiation—Link initiation status of the MP policy, Enable or Disabled. If the link
initiation is enabled, the AP searches its peer AP.
{
Link Maximum Number—Maximum number of mesh links that a radio of an AP can
establish with other APs.
{
Link Hold RSSI—Minimum RSSI to allow a link to be formed and held. Once the RSSI of an
active link is smaller than this value, a link switch happens.
{
Link Hold Time—Minimum time period for keeping an active link up. Within the link hold
time, an active link remains up even if a link switch margin is reached. For more information
about link switch margin and link switching priority, see "
{
Link Saturation RSSI—Maximum RSSI for an active link. If the value is reached, a link switch
happens.
{
Probe Request Interval—Interval for sending probe requests by an AP. The AP sends probe
requests to scan peer APs, responds to responses, and establishes a neighbor table.
{
Operation—Click the Operation icon
of an MP policy to modify or delete the MP policy,
and display the radios bound to the MP policy. You cannot modify or delete the default MP
policy default_mp_plcy.
5.
Click More, and select AP Configuration, Mesh Interface Management, or Mesh Profile
Management to enter the configuration page.
If the MP Policy List contains enough entries, the following navigational aids are displayed.
Navigating the MP Policy List
{
Click the Next Page icon
to page forward in the MP Policy List.
{
Click the Last Page icon
to page forward to the end of the MP Policy List.
{
Click the Previous Page icon
to page backward in the MP Policy List.
{
Click the First Page icon
to page backward to the front of the MP Policy List.
To configure the number of items you want to display on each page, click 8, 15, 50, 100, or
200 at the upper right of the MP Policy List.
6.
On the MP Policy Management page of an AC, radios to be bound to MP policies are
displayed.
Radio list contents
{
Admin Status—Administrative state for the radio. Options are Up and Down.
{
Radio ID—ID of the radio.
{
AP Template Name—Name of the template used by the AP to which the radio belongs.
{
Radio Type—Select a type of the radio from the list. Options are:
−
802.11a
−
802.11b
−
802.11g
−
802.11gn
−
802.11an
{
MP Policy Name—Name of the MP policy to which radios are bound. By default, the default
MP policy default_mp_plcy is bound to all radios.
{
Delete—Click the Delete icon to delete the radios that are not required to be bound to the
MP policy.