H3C Technologies H3C Intelligent Management Center - Manual (Page 172)

150
Group List
{
Binding Status—If this option is selected, the WLAN has been bound to the group. The
default group is selected by default, and cannot be cleared.
{
Group Name—Name of the group.
5. Select one or multiple groups to bind to the WLAN.
6. Click OK.
The Result List page appears, showing the operation results.
Result List
{
Group Name—Name of the group.
{
SSID—SSID of the WLAN.
{
AC—Label of the AC where the WLAN is created.
{
Result—Result for the binding operation.
7. Click Back to go back to the WLAN configuration page.
Deleting a WLAN
If you delete a WLAN whose admin status is Enable, all clients connected to the WLAN are
disconnected.
To delete a WLAN:
1. Click the Service tab.
2. From the navigation tree, select WLAN Manager > Resource Management > ACs.
3. Click the Operation icon for the target AC and select WLAN Configuration from the menu.
The WLAN List displays all WLANs created on the AC.
4. Click the Operation icon for the target WLAN and select Delete from the menu.
5. Click OK in the confirmation dialog box that appears.
Configuring radio parameters for an AC
1. Click the Service tab.
2. From the navigation tree, select WLAN Manager > Resource Management > ACs.
3. Click the Operation icon for the target AC and select Radio Batch Configuration from the
menu.
4. Configure the basic Information:
a. Select Basic Information.
b. Admin Status—Select an admin status for the radio. Options are Up and Down. A radio
can operate only if it is in Up state.
5. Configure the antenna:
a. Select Antenna Config.
b. Antenna—Enable a port for the antenna.
− A—Specify the right port for the antenna.
− B—Specify the left port for the antenna.