H3C Technologies H3C Intelligent Management Center - Manual (Page 568)

546
6. Drag the gray block to the proper position in the topology according to actual iNode client
location.
7. Repeat steps 5 and 6 to add more sampling points.
NOTE:
WSM automatically saves the sampling points that were previously added.
Saving a sampling point
1. Click the Service tab.
2. From the navigation tree, select WLAN Manager > View Management > Location Views.
The Location List page appears.
3. Click the View Topology icon for the location view.
The location view topology page appears, displaying all sub-location views, fit APs and fat APs.
4. Right-click on a blank area, and, from the shortcut menu, select Sampling Points Management >
Client Sampling.
You are in client sampling mode.
5. Right-click on a blank area, and, from the shortcut menu, select Save Sampling Points.
Sampling
After finishing the previous configurations, you can perform the sampling to establish an RSSI
fingerprint database.
NOTE:
The sampling operation is not effective on the sampling points that are being sampled.
To perform the sampling:
1. Click the Service tab.
2. From the navigation tree, select WLAN Manager > View Management > Location Views.
The Location List page appears.
3. Click the View Topology icon for the location view.
The location view topology page appears, displaying all sub-location views, fit APs and fat APs.
4. Right-click on a blank area, and, from the shortcut menu, select Sampling Points Management >
Client Sampling.
You are in client sampling mode.
5. Right-click on a gray block, and, from the shortcut menu, select Sample.
6. From the dialog box, select a MAC address.
The MAC addresses of the iNode clients that are configured as the sampling clients are listed
here.
7. Click OK.
It takes about 2 minutes to perform the sampling. The color of the block indicates the state of the
sampling point as follows:
• —Not sampled.
• —Being sampled.