H3C Technologies H3C Intelligent Management Center - Manual (Page 200)

178
Table 12 shows the key value ranges.
Table 12 Key ranges
Key type 64 bits 128 bits
ASCII A string of 5 alphanumeric characters
A string of 13 alphanumeric
characters
HEX A 10-digit hexadecimal number A 26-digit hexadecimal number
Table 13 shows the cipher default values.
Table 13 Cipher default values
Version Cipher default value (cannot be modified)
WPA TKIP
WPA2 CCMP (AES)
WPA or WPA2 TKIP + CCMP (AES)
7. Configure the radio binding information:
{
Radio Behavior—Select the radios bound to the WLAN. Options are Both Radios, Radio 1
Only, and Radio 2 Only.
8. In the Selected Devices area, select the fat APs where you want to create the WLANs. Options
are All Fat APs and Selected Fat APs.
{
All Fat APs—Select this option to create the WLANs on all managed fat APs in IMC. Then go
to step 14.
{
Selected Fat APs—Select this option to create the WLANs only on the selected fat APs.
If the Selected Fat APs option is selected, the page refreshes to displays the Fat AP List area.
9. In the Fat AP List area, click Add to display the Select Devices dialog box.
10. Enter or select one or more of the following query criteria to search for the fat APs you want to
bind to the WLAN:
{
Device Label—Enter the label of the fat AP. WSM supports fuzzy matching for this field.
{
IP Address—Enter the IPv4 address of the fat AP. WSM supports fuzzy matching for this field.
{
Model—Enter the model of the fat AP. WSM supports fuzzy matching for this field.
{
Connectivity Status—Select a connectivity state for the fat AP. Options are Unlimited,
Reachable, and Unreachable.
{
Location—Enter or select the name of the location view to which the fat AP belongs. WSM
supports fuzzy matching for this field.
If you leave a field empty or set a field to Unlimited, the field does not serve as a query
criterion.
11. Click Query.
The Fat AP List displays all fat APs matching the query criteria. To clear the query criteria and
display all fat APs, click Reset.
NOTE:
To avoid configuration failures, configure fat APs of the same model in batches. If the fat APs are
of more models, configure fat APs of each model separately.