H3C Technologies H3C Intelligent Management Center - Manual (Page 68)

46
4 Fast WLAN deployment
WSM enables you to configure all WLAN parameters on one page to fast deploy a WLAN.
This feature supports only H3C ACs and H3C fit APs.
Configuring WLAN parameters
1. Click the Service tab.
2. From the navigation tree, select WLAN Manager > Fast Deploy WLAN.
3. On the Fast Deploy WLAN page, configure the following parameters:
Basic Information:
{
SSID—Enter a unique SSID for the service template.
{
Enable—Select this option to enable the service template.
{
Bind Radio—Select a radio type to which the service template is bound. Options are 2.4GHz,
5GHz, and All.
{
Hide SSID—Select this option to hide the SSID in beacon frames sent by the fit AP. When this
parameter is selected, clients cannot obtain the SSID from the beacon frames, and they must
configure the SSID before accessing the wireless network. If this parameter is not selected,
clients can obtain the SSID from the beacon frames to access the wireless network.
{
VLAN—Specify a VLAN to which the service template is bound. Clients that access the
WLAN join the VLAN automatically.
Security Information:
Encryption Mode—Select an encryption mode. Options are Clear, WEP, WPA (Personal), WPA2
(Personal), WPA (Enterprise), and WPA2 (Enterprise).
{
Clear—No data frames are encrypted.
{
WEP—WEP encryption is used. Configure the following parameters:
− Cipher Suite—Select a cipher suite. Options are WEP40, WEP104, and WEP128, with
security strength in ascending order.
− Key—Enter a key. The key length varies by the cipher suite. The key length is 5, 13, and
16 alphanumeric characters for WEP40, WEP104, and WEP128 keys, respectively.
− Confirm Key—Enter the key again.
− Key Index—Enter a key index. WEP supports 1 to 4 key indexes.
{
WPA (Personal) or WPA2 (Personal)—PSK authentication is used. Configure the following
parameters:
− PSK—Enter a pre-shared key in the range of 8 to 63 characters.
− Confirm PSK—Enter the PSK again.
{
WPA (Enterprise) or WPA2 (Enterprise)—802.1X authentication is used. Configure the
following parameters:
− RADIUS Policy—Select a RADIUS policy. To configure a RADIUS policy, click RADIUS
Policy. For more information, see "
Configuring a RADIUS policy ."