H3C Technologies H3C Intelligent Management Center - Manual (Page 563)

541
The Policy Server Parameters page displays all policy server parameters.
2. Select Enable for Enable Policy Server.
To configure the wireless locating parameters:
1. Click the Service tab.
2. From the navigation tree, select User Access Manager > Service Parameters > System Settings.
The System Settings list displays all system settings.
3. Click the Configure icon for configuring the wireless locating parameters.
The Wireless Positioning Parameter Configuration page appears.
4. Select Enable Wireless Client Location.
5. Configure the following wireless locating parameters:
{
WSM server IP—Configure the IP address of the server where the WSM component is
deployed.
{
WSM server listening port—Set the listening port of the WSM server. The default value is
6666. The value must be consistent with that configured on the WSM server.
{
Wireless positioning report interval—Set the interval at which each iNode client reports
wireless locating information to the WSM server. A short interval provides accurate locating
information, but requires more system resources of the client PC.
{
iNode consecutive scans—Set how many times an iNode client consecutively scans the
wireless card before reporting the locating information. The iNode client calculates the
scanned information and reports the result to the WSM server. More data provides more
accurate locating information, but requires more system resources of the client PC.
6. Click OK.
Managing concerned client groups
In WSM, only the iNode client used by a concerned user can be set as a sampling point. Before
performing sampling, add access users in UAM as concerned users in WSM.
You can add concerned users in different areas to different concerned client groups to control client
access by using area access policies.
Synchronizing UAM client accounts
WSM synchronizes client accounts automatically from UAM to WSM at 1:00 a.m. every day. You can
also synchronize the clients manually.
To synchronize clients from UAM to WSM:
1. Click the Service tab.
2. From the navigation tree, select WLAN Manager > Locating Management.
The Locating Management page appears.
3. In the Wireless Locating Based on iNode Sampling Points area, click the Concerned Client
Groups link.
The Concerned Client Groups page appears, displaying all concerned client groups.
4. At the upper right of the page, click Synchronize Clients.
The UAM iNode client accounts are synchronized to WSM.