H3C Technologies H3C Intelligent Management Center User Manual
Page 415
393
{
Modify AP—Allows you to modify the antenna type and angle for radios of the fat AP to
adjust its coverage area. For more information, see "
{
Delete Device from this Location—Allows you to delete the fat AP from the current location
view.
{
Lock/Unlock—Allows you to lock/unlock the position of the fat AP on the topology. A fat AP
cannot be moved after being locked.
A right-mouse click on the blank area on the topology will display a menu for pane configuration:
{
Add Location—Allows you to add a sub-location view to the current location view.
{
Add Device to this Location—Allows you to add devices to the location view.
{
Add Virtual APs to this Location—Allows you to add virtual APs to the location view. Virtual
APs are used for network planning.
{
Delete All Virtual APs—Allows you to delete all virtual APs from the location view. This option
does not appear if the location view contains no virtual APs.
{
Show Interference Devices—Select this option to display interference devices on the topology.
{
Show Air Quality—Select Show Air Quality > 802.11 a/an or Show Air Quality >
802.11b/g/gn to show the quality of the channels in the 5GHz frequency band or 2.4GHz
frequency band. The channel quality of a fit AP or fat AP is displayed to the right of the
device icon, with the color growing lighter as the channel quality decreases.
WSM can display the channel quality only for fit APs or fat APs that support RF analysis.
{
Hide Channel Quality—Select this option to hide the channel quality on the topology.
{
Generate Network Planning Report—Allows you to generate the network planning report of
the location view. This option does not appear if the location view contains no virtual AP.
{
Display Coverage Area—Allows you to select to display signal coverage area by signal
strength, data rate, channel, or SSID.
{
Show/Hide Mesh Link—Allows you to show or hide AP mesh links on the current location
view. For more information, see "
{
Show/Hide iNode Client—Allows you to show or hide iNode clients on the current location
view. The iNode clients can be displayed only when the iNode client sampling points are
successfully configured in the wireless locating. For more information, see "
based on iNode sampling points
{
Sampling Points Management—Allows you to enter the sampling management mode. For
more information, see "
Wireless locating based on iNode sampling points
" and "
{
Area Policy Configuration—Allows you to enter the access area configuration mode. For
more information, see "
Configuring area access policies
{
Color Settings—Allows you to set the colors for the signal strength, data rate, and channel of
the APs. For more information, see "
."
{
Show/Hide Stations—Allows you to hide or show clients associated with the APs on the
current location view.
Perform the following operations on the client from the location view topology:
•
Click the icon of a client. The tip window displays the basic information about the client,
including the MAC address, client name, SSID, radio type, signal strength, and RSSI. For
descriptions of these parameters, see "
Viewing the device topology of an AC
."