H3C Technologies H3C Intelligent Management Center - Manual (Page 423)

401
• Click the Next Page icon to page forward in the Device List.
• Click the Last Page icon to page forward to the end of the Device List.
• Click the Previous Page icon to page backward in the Device List.
• Click the First Page icon to page backward to the front of the Device List.
Click 8, 15, 50, 100, or 200 at the upper right of the Device List to configure how many items per
page you want to display.
NOTE:
You can sort the Device List by every field. Click the column label to sort the list by the selected field.
The column label allows you to toggle between the sort options specific to each field. AC is always
displayed in the first line of the list no matter what sort criterion you have specified.
Querying detect fit APs
1. Click the Service tab.
2. From the navigation tree, select WLAN Manager > WIDS Management > WIDS Config.
The ACs list displays all managed ACs in WSM.
3. Click the number link in the Detector column of an AC.
The Device List displays all the fit APs managed by the AC with a work mode of Monitor or
Hybrid.
4. In the Device Query area, enter or select one or more of the following query criteria:
{
AP Label—Enter a partial or complete device label for the AP.
{
AP Name—Enter a partial or complete device name for the AP.
{
Serial Number—Enter a partial or complete serial number for the AP.
{
IP Address—Enter a partial or complete IP address for the AP.
{
AC—This field displays the AC name.
5. Click Query. The Device List displays all ACs matching the query criteria. Click Reset to clear
the query criteria and display all ACs.
Enabling/disabling fit APs to detect rogue APs
1. Click the Service tab.
2. From the navigation tree, select WLAN Manager > WIDS Management > WIDS Config.
The ACs list displays all managed ACs in WSM.
3. Click the number link in the Detector column of an AC.
The Detect Fit AP List page appears.
4. Click Enable Detecting Fit AP in the Device List area.
The Enable Detecting Fit AP page appears.
5. Perform either of the following depending the AC vendor.
{
For a Comware-based AC:
Select the work mode for the fit APs in the Configure AP Work Mode area. Options are
Normal, Monitor, and Hybrid. To enable fit APs to detect rogue APs, set this field to Monitor
or Hybrid.
{
For an MSM series AC: