H3C Technologies H3C Intelligent Management Center - Manual (Page 319)

297
− 802.11n(2.4GHz)
− 802.11n
− 802.11n(5GHz)
− 802.11ag
− Wired
{
AP—Device label of the fit AP or fat AP connected to the client. Click the label link of an AP
to view detailed information about the AP.
{
AC—Device label of the AC of the client. Click the label link of an AC to view detailed
information about the AC. This parameter is not displayed when the client is connected to a
fat AP.
{
Client Status—Current association status of the client. Options are succeeded or failed.
Association succeeded means the access AP accepts the association request of the client.
Association failed means the access AP rejects the association request of the client.
{
Sample—Indicates whether the client is a sampling client. A sampling client is used for
sampling when WSM performs AP-based wireless locating.
{
VLAN ID—Access VLAN ID of the client.
{
Power Save Mode—Indicates whether the power save mode is enabled for the client.
{
Transmission Rate Set—Transmission rate set of the client. Options are mandatory rate set
and supported rate set. Mandatory rate means that the client must use the transmission rate
set. Supported rate means that the client can choose to use the transmission rate set.
{
Location—Location view name of the access AP.
{
Channel—Working channel of the fit AP's radio with which the client is associated.
Security Information
{
Authorization Mode—Authorization mode of the client defined in 802.11. Options are:
− Open System—No authentication is performed for any client that request for
authentication.
− Shared Key—The client must be configured with the same shared key as the device. This
option is available only when the cipher suite is WEP40 or WEP104.
− All—Both Open System and Shared Key are configured.
Clients select a proper authentication mode as needed when accessing the network.
{
Encryption Mode—Encryption mode of the access WLAN for the client. Options are:
− plaintext—the client can access the wireless network without providing password
− ciphertext—the client must provide the password to access the wireless network.
{
AKM Type—Password type defined by 802.11i for the client. Options are:
− None
− PSK
− 802.1X
{
Signal Quality Reception Rate (Mbps)—Current reception rate of the client.
{
Transmission Rate (Mbps)—Current Transmission rate of the client.
{
Received Noise—Current received noise of the client.
{
Signal Noise Ratio—Current signal noise ratio of the client.
{
Signal Strength (dBm)—Signal strength of client obtained by the access AP.