H3C Technologies H3C Intelligent Management Center - Manual (Page 142)

120
{
Modify—Click the Modify icon to modify the RRM calibration group.
{
Delete—Click the Delete icon to delete the RRM calibration group.
If the RRM Calibration Group List contains enough entries, the following navigational aids are
displayed.
Navigating the RRM Calibration Group List
• Click the Next Page icon to page forward in the RRM Calibration Group List.
• Click the Last Page icon to page forward to the end of the RRM Calibration Group List.
• Click the Previous Page icon to page backward in the RRM Calibration Group List.
• Click the First Page icon to page backward to the front of the RRM Calibration Group List.
Click 8, 15, 50, 100, or 200 at the upper right of the RRM Calibration Group List to configure the
number of items per page you want to display.
NOTE:
You can sort the RRM Calibration Group List by ID, Channel Hold Time, and Power Hold Time fields.
Click the column label to sort the list by the selected field. The column label allows you to toggle
between the various sort options specific to each field.
Adding an RRM calibration group
1. Click the Service tab.
2. From the navigation tree, select WLAN Manager > Resource Management > ACs. The AC List
page displays all ACs.
3. Click the device label of the target AC.
4. Click the RRM Calibration Group link in the RRM Management area to the right of the page. All
the RRM calibration group information of the AC is displayed in the RRM Calibration Group List.
5. Click Add. The page for adding an RRM calibration group appears.
6. Set the following parameters as needed:
{
ID—Enter the ID of the RRM calibration group.
{
Channel Hold Time (M)—Enter a channel hold-down time of the radios in the RRM calibration
group.
{
Power Hold Time (M)—Enter a power hold-down time of the radios in the RRM calibration
group.
{
Description—Enter a description for the RRM calibration group.
7. Click OK.
Modifying an RRM calibration group
1. Click the Service tab.
2. From the navigation tree, select WLAN Manager > Resource Management > ACs. The AC List
page displays all ACs.
3. Click the device label of the target AC.
4. Click the RRM Calibration Group link in the RRM Management area to the right of the page. All
the RRM calibration group information of the AC is displayed in the RRM Calibration Group List.
5. Click the Modify icon for the RRM calibration group you want to modify.