Adding a mesh interface, Configuring port security for mesh interfaces, Configuring port security for – H3C Technologies H3C Intelligent Management Center User Manual
Page 606: Mesh interfaces
584
Adding a mesh interface
1.
Click the Service tab.
2.
From the navigation tree, select WLAN Manager > Resource Management > ACs or WLAN
Manager > Resource Management > Fat APs.
3.
Click the device label of an AC or fat AP to enter the device information page.
4.
On the Mesh Management menu on the lower right corner of the page, click Mesh Interface
Management.
The Mesh Interface Management page appears.
5.
Click Add Interface to enter the Add Interface page.
6.
Enter an interface ID.
A description is generated based on the interface ID. For example, if you enter 10 as the
interface ID, the description for the interface is WLAN-MESH10.
7.
Click OK.
The operation result is displayed. If the operation fails, the failure reason is displayed.
8.
Click Back to return to the Mesh Interface Management page.
Configuring port security for mesh interfaces
After you add a mesh interface, you must configure port security for the interface. Otherwise,
noRestrictions is displayed for the port security mode of the interface in the mesh interface list.
To configure port security for a mesh interface:
1.
Click the Service tab.
2.
From the navigation tree, select WLAN Manager > Resource Management > ACs or WLAN
Manager > Resource Management > Fat APs.
3.
Click the device label of an AC or fat AP to enter the device information page.
4.
On the Mesh Management menu on the lower right corner of the page, click Mesh Interface
Management.
The Mesh Interface Management page appears.
5.
Use one of the following methods to enter the Modifying Port Security page:
Method 1—Modify port security for one interface:
a.
Click the Operation icon
of a mesh interface.
b.
Select
Modify Port Security from the menu.
Method 2—Modify port security for multiple interfaces:
c.
Select the mesh interfaces for which you want to modify the port security mode.
d.
Click Modifying Port Security.
6.
Set the following parameters:
{
Description—Description for the mesh interface, comprising WLAN-MESH and interface ID.
This field cannot be modified, and does not appear when you modify the port security mode
for multiple interfaces.