Ap association summary report – H3C Technologies H3C Intelligent Management Center User Manual
Page 642
620
•
Received Traffic (MB)—Total traffic received by the AC.
•
Packet Retransmit Ratio (%)—Ratio of the number of retransmitted packets to the total number of
transmitted packets.
•
Error Frame Ratio (%)—Ratio of the number of error frames to the total number of frames
received by the AC.
•
Max Transmit Speed (Mb/s)—Maximum transmission speed of the AC.
•
Avg Transmit Speed (Mb/s)—Average transmission speed of the AC.
•
Max Receive Speed (Mb/s)—Maximum reception speed of the AC.
•
Avg Receive Speed (Mb/s)—Average reception speed of the AC.
•
Max Online Client Number—Maximum number of online clients on the AC.
•
Avg Online Client Number—Average number of online clients on the AC.
•
AP Average Utilization (%)—Average use of the fit APs managed by the AC, calculated as Avg
Online Client Number/X, where X is the AP usage value specified in the configuration file.
•
AP Peak Utilization (%)—Peak use of the fit APs managed by the AC, calculated as Max Online
Client Number/X, where X is the AP usage value specified in the configuration file.
•
Total Client Online Duration—Total online duration of the clients.
•
Avg Client Online Duration—Average online duration of the clients.
•
Successful Accesses—Total number of times the clients have associated successfully with the APs
managed by the AC.
•
Success Rate (%)—Ratio of successful accesses to the total number of access requests.
•
Association Congestion Rate (%)—Client association congestion rate of the AC, which is the ratio
of association failures to the total number of association requests.
•
Client Dropping Rate (%)—Client dropping rate of the AC, which is the ratio of client abnormal
logouts to the total number of online clients.
AP association summary report
This report displays the summary client association statistics for all APs or APs in a location view. If the
location view has sub-locations, the report also displays the summary and top 10 client association
statistics for the location view and its sub-locations.
To view an AP association summary report, configure the following parameters:
•
Parameter "Begin Time and End Time"—Select a statistics collection time range from the list. You
can select a specific time range, such as Last Hour, Last Week, or Last Month, or select Custom
Range, and then specify the start time and end time manually.
•
Location—Select a specific location view for statistics collection, or select All AP Devices.
•
Begin Time/End Time—These two parameters appear only when you select Custom Range. Click
the field next to Begin Time/End Time to select the start time/end time from the calendar that
appears, in the format of YYYY-MM-DD hh:mm. The end time must be later than the start time.
shows an example AP association summary report.