H3C Technologies H3C Intelligent Management Center - Manual (Page 442)

420
• Blocked address list—A blocked address list contains the MAC addresses of prohibited APs or
clients. WIPS uses the list to categorize APs and clients, and WIPS can also prohibit clients in the
list from accessing the WLAN.
WIPS networking
WIPS can operate independently or in an existing WLAN.
Independent networking
ACs and sensors (fit APs) operating in monitor mode form a WIPS network, as shown in Figure 54 .
The WIPS network is independent of the WLAN to be protected.
Figure 54 Network diagram
Operating in an existing WLAN
You can deploy WIPS in an existing WLAN by enabling WIPS on the ACs and APs in the WLAN,
and configure the sensors to operate in monitor mode or in hybrid mode, as shown in Figure 55 .
Figure 55 Network diagram