H3C Technologies H3C Intelligent Management Center - Manual (Page 660)

638
To view a rogue AP history report, configure the following parameters:
• Parameter "Begin Time and End Time"—Select a statistics collection time range from the list. You
can select a specific time range, such as Last Hour, Last Day, Last Week, or Last Month, or
select Custom Range, and then specify the start time and end time manually.
• Begin Time/End Time—These two parameters appear only when you select Custom Range. Click
the field next to Begin Time/End Time to select the start time/end time from the calendar that
appears, in the format of YYYY-MM-DD hh:mm. The end time must be later than the start time.
Figure 98 shows an example rogue AP history report.
Figure 98 Rogue AP history report
Rogue AP history report fields:
• Report Period—Time range during which the statistics are collected.
• MAC Address—MAC address of the rogue AP.
• Vendor—Vendor of the rogue AP.
• SSID—SSID of the rogue AP.
• Max Signal Strength—Maximum signal strength of the rogue AP.
• Channel—Channel used by the rogue AP.
• Detected by—AC that detected the rogue AP.
• Detected AP—Fit AP that discovered the rogue AP.
• Last Discovered Time—Time when the rogue AP was last discovered.
• Status—State of the rogue AP, Attacked or Not Attacked.
Rogue AP report
This report displays all the newly detected rogue APs by MAC address.