Disabling spectrum analysis/fft monitoring, Configuring channels to be monitored, Viewing current interferences – H3C Technologies H3C Intelligent Management Center User Manual
Page 536: Viewing the current interference list
514
Disabling spectrum analysis/FFT monitoring
1.
Click the Service tab.
2.
From the navigation tree, select WLAN Manager > Spectrum Guard > Radio Config.
The Radio Config page appears.
3.
From the Radio List, select APs for which you want to disable spectrum analysis/FFT monitoring.
4.
Click Disable Analysis or Disable FFT.
The Result List page shows the operation result of each radio.
5.
Click Back to return to the Radio Config page.
Configuring channels to be monitored
For the 5 GHz band, you can change the channels that radios monitor.
To configure channels to be monitored:
1.
Click the Service tab.
2.
From the navigation tree, select WLAN Manager > Spectrum Guard > Radio Config.
The Radio Config page appears.
3.
From the Radio List, select radios for which you want to configure channel monitoring.
When multiple radios are selected, make sure the radios are operating at the same frequency.
4.
Click Monitor Channels.
The Monitor Channels window appears.
5.
Select the channel range.
Applicable channel ranges vary by regions.
6.
Click OK.
Viewing current interferences
You can view, query, and locate current interferences on the WLAN to eliminate the interferences. The
following interferences can be detected by AC:
•
microwave ovens
•
Bluetooth
•
fixed frequency
•
fixed frequency video devices
•
cordless phone
•
Microsoft Xbox
Viewing the current interference list
1.
Click the Service tab.
2.
From the navigation tree, select WLAN Manager > Spectrum Guard > Interferences.
The Interferences page appears.