H3C Technologies H3C Intelligent Management Center - Manual (Page 267)

245
Viewing radio parameters for a fit AP
1. Click the Service tab.
2. From the navigation tree, select WLAN Manager > Resource Management > Fit APs.
The Fit AP List page displays all fit APs.
3. Click the device label of the target fit AP.
The fit AP details page displays the basic information, client information, and radio information
for the current fit AP.
4. In the Radio Interface area, click the ID of the target radio.
The Radio Information dialog box appears.
Radio Information
{
Radio ID—ID of the radio.
{
Radio Type—Type of the radio. Options are:
− 802.11a
− 802.11b
− 802.11g
− 802.11bg
− 802.11at
− 802.11an
− 802.11gn
− 802.11n(2.4GHz)
− 802.11bgn
− 802.11n
− 802.11n(5GHz)
{
Admin Status—Administrative state of the radio. Options are Up and Down.
{
Channels in Use—Working channel of the radio. The value range depends on the radio type.
If you select Auto, the fit AP selects an optimum channel as the working channel.
{
Current Transmission Power (dBm)—Current transmission power of the radio.
{
Operating Mode—Operation mode of the radio. Options are:
− Access Point Only (Periodic RF Detection)
− Access Point and Local Mesh (Periodic RF Detection)
− Local Mesh Only (Periodic RF Detection)
− Monitor (Dedicated RF Detection)
− Sensor (Dedicated RF Detection)
{
Description—Description for the radio.
{
SSID—SSID of the WLAN bound to the group to which the fit AP belongs.
5. Click Close.