H3C Technologies H3C Intelligent Management Center - Manual (Page 363)

341
The Device List page displays all rogue AP access ports and the related rogue AP information.
4. Enter or select one or more of the following query criteria:
{
MAC Address—Enter a partial or complete MAC address of the rogue AP. WSM supports
fuzzy matching for this field.
{
SSID—Enter a partial or complete SSID of the WLAN to which the rogue AP accesses. WSM
supports fuzzy matching for this field.
An empty field or a field that is set to Unlimited does not serve as a query criterion.
5. Click Query.
The Device List displays all rogue AP access ports matching the query criteria.
6. Click Reset to clear the query criteria and display all rogue AP access ports.
Configuring PoE on rogue AP access ports
If the access device directly connects to the rogue AP and the AP access port supports the PoE
function, you can enable or disable the PoE function on the AP access port. For more information, see
" Configuring PoE on a fit AP access port ."
Configuring automatic rogue AP isolation
To enhance security, WSM provides the automatic rogue AP isolation function. With this function
enabled, WSM automatically shuts down all AP access ports that directly connect to rogue APs.
To configure automatic rogue AP isolation:
1. Click the Service tab.
2. From the navigation tree, select WLAN Manager > Resource Management > Access Ports.
The AP Access Ports page appears.
3. Click the Rogue AP tab.
The Device List page displays all rogue AP access ports and the related rogue AP information.
4. To enable the automatic rogue AP isolation function:
a. Click Auto Rogue AP Isolation on the upper right of the list
b. Click OK in the confirmation dialog box.
5. To disable the automatic rogue AP isolation function:
a. Click Cancel Rogue AP Isolation on the upper right of the list
b. Click OK in the confirmation dialog box.