Gis locating, Locating an ap, Locating – H3C Technologies H3C Intelligent Management Center User Manual
Page 578
556
The Rogue AP List displays all rogue APs.
3.
Click the Operation icon
of a rogue AP to be located, and, from the menu, select
Locate.
The rogue AP is displayed and highlighted in the location view topology.
To locate a rogue AP by topology:
1.
Click the Service tab.
2.
From the navigation tree, select WLAN Manager > Wireless Topology.
The wireless device topology page appears, displaying all ACs and fat APs.
3.
Double-click the AC icon, or right-click the AC icon and, from the shortcut menu, select Open
Topology.
The topology page of the AC appears.
4.
Right-click on a blank area, and, from the shortcut menu, select Show Devices > Show Rogues.
All rogue APs and clients are displayed and are associated with the fit APs that discovered
them.
5.
Right-click the rogue AP icon, and, from the shortcut menu, select Locate.
The rogue AP is displayed and highlighted in the location view topology.
Because WSM continuously adjusts the location result, the initially located location might be
different from the finally located location. If no location result is displayed ten minutes later, the
locating operation automatically stops, and a prompt that indicates the failure appears on the
message bar.
6.
To stop the locating operation, right-click on a blank area, and, from the shortcut menu, select
Stop Locate.
GIS locating
GIS locating is used to locate APs or clients in GIS view. It is typically applied in enterprises that have
multiple branches.
Before performing GIS locating, add location views to GIS view. Then WSM can locate APs
according to the APs' location views, and locate clients according to the location views of the APs
with which the clients are associated.
For information about adding location views to GIS view, see "
NOTE:
•
Administrators and maintainers can edit the map on GIS view, while the viewers can only view the
map.
•
Double-click the map to zoom in the map, and right-double-click the map to zoom out the map.
Locating an AP
1.
Click the Service tab.
2.
To enter the device list page, use one of the following procedures:
From the navigation tree, select WLAN Manager > Resource Management > Fat APs or
WLAN Manager > Resource Management > Fit APs.