H3C Technologies H3C Intelligent Management Center - Manual (Page 215)

193
{
Current Transmission Power (dBm)—Current transmission power of the radio, in dBm.
RF Neighbor Detection
{
Use Interval—Whether RF neighbor detection is enabled.
{
Interval (s)—RF neighbor detection interval.
{
Detection Mode—RF neighbor detection mode: Periodic or Dedicated. If Radio Operating
Mode is set to Access Point and Local Mesh, Access Point Only, or Local Mesh Only, the
Detection Mode is Dedicated. If Radio Operating Mode is set to Monitor or Sensor, the
Detection Mode is Periodic.
6. Click Back to return to the Fat AP Details page.
Modifying the radio parameters for a fat AP
1. Click the Service tab.
2. From the navigation tree, select WLAN Manager > Resource Management > Fat APs. The Fat
AP List page displays all fat APs.
3. Click the device label of a fat AP to enter the Fat AP Details page.
4. Click the Wireless Service Information tab.
All wireless service information for the selected fat AP is displayed in this tab.
5. On the Radio Information list, click the Modify icon for the radio you want to modify.
The Modify Fat AP Radio Parameters page appears.
6. Modify the following parameters for the radio:
{
Radio ID—Cannot be modified.
{
Radio Type—Select a new radio type from the list. These are the radio type option:
− 802.11a
− 802.11b
− 802.11g
− 802.11bg
− 802.11at
− 802.11an
− 802.11gn
− 802.11n (2.4GHz)
− 802.11bgn
− 802.11n
− 802.11n(5GHz)
{
Channels in Use—Select the working channel used by the fat AP. Available channels depend
on the radio type. If Auto is selected, the fat AP automatically selects an idle channel as the
working channel of the radio.
{
Admin Status—Select an administrative state for the radio. Options are Up and Down.
{
Max Transmission Power (dBm)—Enter the maximum transmission power of the radio, in
dBm.
{
Current Transmission Power (dBm)—Current transmission power of the radio, in dBm.