H3C Technologies H3C Intelligent Management Center - Manual (Page 234)

212
− Clear Mode—No data packets need to be encrypted.
− Crypto Mode—All data packets need to be encrypted.
{
Hide SSID—Whether the SSID is hidden in beacon frames sent by the fat AP. When this
parameter is specified, clients cannot obtain the SSID from the beacon frames and must
configure the SSID before accessing the wireless network. If this parameter is not specified,
clients can obtain the SSID from the beacon frames to access the wireless network.
{
Authentication Mode—Specify the authentication mode of the service policy.
− Open System—Allows all clients requesting for authentication to directly pass
authentication.
− Shared Key—Requires clients to use the same shared key as that configured on the
device. Specify Shared Key only when you select WEP40 or WEP104 as the cipher suite.
− All—Allows clients to use either the Open System mode or the Shared Key mode as
needed.
When the encryption mode is Clear, the authentication mode can only be Open System.
When the encryption mode is Crypto, the authentication mode options are Open System,
Shared Key, and All.
2. Specify the service policy template you want to use.
3. Click OK.
4. In the Add Service Policy area on the page for creating service policies in batches, enter an ID
of the service policy to uniquely identify the service policy on the fat AP.
5. In the Fat AP List area, click Add.
The Select Device dialog box appears.
6. Enter or specify one or more of the following query criteria to search for the fat APs you want to
configure:
{
Device Label—Enter the label of the fat AP. WSM supports fuzzy matching for this field.
{
IP Address—Enter a partial or complete IPv4 address of the fat AP. WSM supports fuzzy
matching for this field.
{
Model—Enter the model of the fat AP. WSM supports fuzzy matching for this field.
{
Connectivity Status—Specify a connectivity state for the fat AP. Options are Unlimited,
Reachable, and Unreachable.
{
Location—Enter or specify the name of the location view to which the fat AP belongs. WSM
supports fuzzy matching for this field.
An empty field or a field that is set to Unlimited does not serve as a query criterion.
7. Click Query.
The Fat AP List displays all fat APs matching the query criteria. Click Reset to clear the query
criteria and display all fat APs.
8. Specify the target fat APs.
9. Click OK to close the Select Device window.
The Fat AP List displays all selected fat APs.
10. Click OK.
The Result List page appears, displaying the operation result for creating service policies in
batches.
11. Click Back to go back to the page for creating service policies in batches.