H3C Technologies H3C Intelligent Management Center - Manual (Page 246)

224
The Fat AP List page displays all fat APs.
3. Click the Operation icon for the target fat AP.
4. Select Service Policy from the menu.
The Service Policy Management page appears. All service policy information for the fat AP is
displayed on Service Policy List.
5. Click Select Template.
All service policy templates in WSM are displayed in the list.
Select Service Policy Template contents
{
SSID—SSID of the service policy.
{
Encryption Mode—Encryption mode for the service policy: Clear or Crypto. The Clear mode
means that no data packets need to be encrypted. The Crypto mode means that all data
packets need to be encrypted.
{
Hide SSID—Whether the SSID is hidden in beacon frames sent by the fat AP. When this
parameter is selected, clients cannot obtain the SSID from the beacon frames and must
configure the SSID before accessing the wireless network. If this parameter is not selected,
clients can obtain the SSID from the beacon frames to access the wireless network.
{
Authentication Mode—Authentication mode of the service policy. Options are:
− Open System—Allows all clients requesting for authentication to directly pass
authentication.
− Shared Key—Requires clients to use the same shared key as that configured on the
device. Specify Shared Key only when you select WEP40 or WEP104 as the cipher suite.
− All—Allows clients to use either the Open System mode or the Shared Key mode as
needed.
6. Specify the service policy template you want to use.
7. Click Next.
8. Enter an ID of the service policy to uniquely identify the service policy on the fat AP.
9. Click OK.
The Result List page appears, displaying operation results for adding service policies.
10. Click Back to go back to the Service Policy Management page of the current fat AP.
Modifying a service policy
1. Click the Service tab.
2. From the navigation tree, select WLAN Manager > Resource Management > Fat APs.
The Fat AP List page displays all fat APs.
3. Click the Operation icon for the target fat AP.
4. Select Service Policy from the menu.
The Service Policy Management page appears. All service policy information for the fat AP is
displayed on Service Policy List.
5. Click the Operation icon for the service policy you want to modify.
6. Select Modify from the menu.
The Modify Service Policy page appears.