H3C Technologies H3C Intelligent Management Center - Manual (Page 584)

562
{
Policy Name—Enter a unique energy policy name.
{
Policy Type—Select an operation type for the energy. Options are:
− Start/Stop AP—Enables or disables PoE on PoE-capable AP access ports on the access
devices (typically switches) to power on or power off APs.
− Start/Stop Radio—Changes the management status of radios to up or down to power on
or power off radios.
− Modify Radio Power—Changes or restores the radio transmission power.
− Start/Stop SSID—Binds SSIDs to radios or unbinds SSIDs from radios. For Comware-
based devices, SSIDs are service policies. For MSM series devices, SSIDs are WLANs.
{
SSID—Select target SSIDs. This field appears only when the policy type is Start/Stop SSID.
Use the following procedure to select a target SSID:
a. Click Select SSID.
The Select Device window appears.
b. Enter the query criterion.
c. Click Query.
d. The SSID List displays all SSIDs matching the query criterion.
e. Select the SSIDs you want to manage.
f. Click OK.
All selected SSIDs appear in the SSID box.
{
Execution Mode—Select the mode in which the energy policy is to be executed. Options are
One-off and Periodical.
Configure the following parameters if One-off is selected:
− From the list to the right of the One-off box, select the operation you want WSM to
perform. The operation options are Start/Stop, Start, and Stop for an energy policy of
the start/stop type, and are Change/Restore, Change, and Restore for an energy policy
of the Modify Radio Power type.
− Stopped at—Select the time at which you want WSM to power off APs, radios, or SSIDs,
at the scheduled time or immediately after the energy policy is added. If Scheduled is
selected, enter the scheduled time in YYYY-MM-DD hh:mm:ss format in the box to the
right of the Scheduled box or click the calendar icon to select the scheduled time. The
parameter appears only when Start/Stop or Stop is selected for the One-off box. The
stop time cannot be the same as the start time and cannot be earlier than the current time.
− Started at—Select the time at which you want WSM to power on APs, radios, or SSIDs,
at the scheduled time or immediately after the energy policy is added. If Scheduled is
selected, enter the scheduled time in YYYY-MM-DD hh:mm:ss format in the box to the
right of the Scheduled box or click the calendar icon to select the scheduled. The
parameter appears only when Start/Stop or Start is selected for the One-off box. The
start time cannot be the same as the stop time and cannot be earlier than the current time.
− Recovered at—Select the time at which you want WSM to restore the power of radios, at
the scheduled time or immediately after the energy policy is added. If Scheduled is
selected, enter the scheduled time in YYYY-MM-DD hh:mm:ss format in the box to the
right of the Scheduled box or click the calendar icon to select the scheduled time. The
parameter appears only when Change/Restore or Restore is selected for the One-off box.
The restore time cannot be the same as the change time and cannot be earlier than the
current time.