H3C Technologies H3C Intelligent Management Center - Manual (Page 232)

210
The Fat AP List displays all fat APs matching the query criteria. Click Reset to clear the query
criteria and display all fat APs.
9. Specify the target fat APs.
10. Click OK to close the Select Device window.
The Fat AP List displays all selected fat APs.
11. Click OK.
The Result List page appears, displaying the operation result for modifying the VLAN for fat APs
in batches.
12. Click Back to go back to the page for modifying VLANs in batches.
Configuring service policies in batches
A service policy is a collection of WLAN access parameters that enable a fat AP to provide WLAN
access services when the policy is bound to a radio of the fat AP. Different radios can use the same
service policy, and each radio can be bound to multiple service policies.
The same service policies can be configured for different fat APs to provide wireless services. To
facilitate service policy configuration, WSM enables operators to create, modify, and delete service
policies for fat APs in batches.
Creating service policies in batches
Operators can create service policies in batches, or select service policies from an existing service
policy template. For more information about service policy template management, see "
Managing
policy templates ."
To create service policies in batches:
1. Click the Service tab.
2. From the navigation tree, select WLAN Manager > Configuration Management.
The Configuration Management appears.
3. Click the Comware-Based tab.
4. In the Fat AP Batch Configuration Management (H3C) area, click the Service Policies Batch
Configuration link.
The Service Policies Batch Configuration page appears.
5. Specify and set the following parameters as needed, or specify service policies from an existing
service policy template.
To create service policies in batches, configure the following basic and security parameters:
Basic Information
{
Policy ID—Enter an ID of the service policy to uniquely identify the service policy on the fat
AP.
{
Enable—Specify this option if you want to enable the service policy immediately when it is
applied to the fat AP. Otherwise, do not specify this option.
{
SSID—Enter the SSID of the service policy, which must be unique.
{
Encryption Mode—Specify the encryption mode for the service policy. Options are:
− Clear Mode—No data packets need to be encrypted.
− Crypto Mode—all data packets need to be encrypted.