H3C Technologies H3C Intelligent Management Center - Manual (Page 160)

138
− IP Address—Enter a partial or complete IPv4 address of the AC.
− Device Status—Select a device state for the AC. Options are: Unlimited, Critical, Major,
Minor, Warning, Normal, Unmanaged, and Unknown.
− Connectivity Status—Select a connectivity state for the AC. Options are Unlimited,
Reachable, and Unreachable.
− Vendor—Select the vendor of the AC. Options are Unlimited, H3C, HP, Cisco, and
Aruba.
b. Click Query. The Device List displays all ACs matching the query criteria.
c. Click Reset to clear the query criteria and display all ACs.
Viewing detailed information about an AC
1. Click the Service tab.
2. From the navigation tree, select WLAN Manager > Resource Management > ACs.
3. Click the device label of the AC whose detailed information you want to view.
This section only describes wireless service information about the AC. For other information
displayed on the AC details page, see H3C IMC Base Platform Administrator Guide.
4. Click the Wireless Service Information tab on the lower part of the page.
Global Parameter Information
{
Max APs—Maximum number of fit APs that can be managed by the AC.
{
Online Fit APs—Number of online fit APs managed by the AC.
{
Online Clients—Number of clients that have been associated with the fit APs managed by
the AC.
5. Click the Global Configuration link to configure global parameters for the AC. For more
information, see "
Configuring global parameters for an AC ."
Configuring global parameters for an AC
The global parameters of an AC take effect on all fit APs managed by the AC.
The AC automatically adjusts the transmission power level for radios according to TPC configuration
to avoid interference between radios caused by too-large power. You can also perform one-time TPC
for all radios.
The global parameters of radio 1 take effect on 802.11b/g/n radios. The global parameters of radio
2 take effect on 802.11a/n radios. For example, if you disable the network status of radio 1, all
802.11b/g/n radios are unavailable.
To configure global parameters for an AC:
1. Click the Service tab.
2. From the navigation tree, select WLAN Manager > Resource Management > ACs.
3. Click the device label link of the AC whose detailed information you want to view.
4. Click the Wireless Service Information tab on the lower part of the page.
5. Click the Global Configuration link in the Wireless Service Information area.
6. Configure global parameters for radio 1: