H3C Technologies H3C Intelligent Management Center - Manual (Page 287)

265
− Monitor—The fit AP monitors all devices in the WLAN, but it does not provide WLAN
services.
− Hybrid—The fit AP can both scan devices in the WLAN and act as a wireless access
point.
{
Respond to Broadcast Probes—Enable or disable the fit AP to respond to the broadcasts sent
by clients.
{
Connection Priority—Enter the connection priority of the fit AP. If multiple ACs are available,
the fit AP connects to the AC with the highest connection priority. The value range is 0 to 7.
A greater value represents a high priority.
{
Client Idle-Timeout Interval (s)—Enter the maximum interval for which the link between the fit
AP and a client can be idle. If the fit AP does not receive any frame sent by the client within
the maximum interval, the AC terminates the connection between the fit AP and the client.
{
Client Keep-Alive Interval (s)—Enter the client keep-alive interval. The keep-alive mechanism
is used to detect clients segregated from the system. The fit AP sends probe requests to a
client. If the fit AP cannot receive any response, the AC terminates the connection between
the fit AP and the client.
{
Description—Enter a description for the fit AP.
{
Enable Mesh Portal Service—Enable or disable mesh portal service for the fit AP. Yes means
to enable the mesh portal service and the fit AP can operate as an MPP in a mesh network.
No means not to enable the mesh portal service. Before configuring this parameter, make
sure the fit AP supports mesh. If the fit AP does not support mesh, the configuration fails. For
more information, see the device manual of the fit AP.
7. Click OK.
Restarting a fit AP
You can only restart online fit APs.
To restart a fit AP:
1. Click the Service tab.
2. From the navigation tree, select WLAN Manager > Resource Management > ACs.
3. The AC List page displays all ACs.
4. Click the Operation icon for the target AC, and from the menu, select Fit AP List.
The Fit AP List page displays all fit APs.
5. Click the device label of the fit AP you want to restart.
The fit AP details page appears.
6. In the Action menu located on the right of the page, click Reset.
A confirmation dialog box appears.
7. Click OK.
Deleting a fit AP/fit AP template
The fit AP template corresponding to an online fit AP cannot be deleted. To delete the template,
restart the fit AP.
To delete a fit AP/fit AP template: