H3C Technologies H3C Intelligent Management Center - Manual (Page 268)

246
Modifying radio parameters for a fit AP
1. Click the Service tab.
2. From the navigation tree, select WLAN Manager > Resource Management > Fit APs.
The Fit AP List page displays all fit APs.
3. Click the device label of the target fit AP.
4. In the Radio Interface area, click the Modify icon for the target radio.
The Modify Radio Parameters page appears.
5. Modify the following radio parameters, as needed:
{
Radio ID—ID of the radio. This field cannot be modified.
{
Inherited—Select this option to inherit the radio parameters of the group to which the fit AP
belongs. This setting takes effect on all radios of the fit AP. If you select this option for any
radio on a fit AP, all the other radios on the fit AP also inherit the radio parameters from the
fit AP group.
If this option is not selected, configure the following parameters:
{
Radio Type—Select a radio type. Options are:
− 802.11a
− 802.11b
− 802.11g
− 802.11bg
− 802.11at
− 802.11an
− 802.11gn
− 802.11n(2.4GHz)
− 802.11bgn
− 802.11n
− 802.11n(5GHz)
{
Max Transmission Power (dBm)—Enter the maximum transmit power of the radio.
{
Current Transmission Power (dBm)—Current transmission power of the radio, in dBm.
{
Admin Status—Select the administrative state for the radio. Options are Up and Down.
{
Channels in Use—Select the working channel of the radio. The value range depends on the
radio type. If you select Auto, the fit AP evaluates the channel quality and selects an
optimum channel as the working channel.
{
Operating Mode—Enter the operating mode of the radio. Options are:
− Access Point Only
− Access Point and Local Mesh
− Local Mesh Only
− Monitor
− Sensor
Support for the operation mode depends on the fit AP model.