H3C Technologies H3C Intelligent Management Center - Manual (Page 535)

513
5. Perform an advanced query:
a. Click next to the Query field to expand the Query area. Click it again to hide the Query
area.
b. Enter or select one or more of the following query criteria:
{
AP Label—Enter the AP label. WSM supports fuzzy matching for this field.
{
Serial Number— Enter the AP serial number. WSM supports fuzzy matching for this field.
{
AP Model—Enter the AP model. WSM supports fuzzy matching for this field.
{
Radio Type—Enter the radio type. Options are:
− All
− 802.11a
− 802.11b
− 802.11g
− 802.11an
− 802.11gn
{
Analysis Status—Select the spectrum analysis status of the radio. Options are All, Enable,
and Disable.
{
FFT State—Select the FFT status of the radio. Options are All, Enable, and Disable.
{
Location—Select location in one of the following ways:
− Enter the location view of the AP that uses the radio.
− Click the field, and select the location view from the list that appears.
{
AC—Select an AC. All radios of the APs managed by the AC are queried.
An empty field or a field that is set to All does not serve as a query criterion.
c. Click Query.
The Radio List displays all radios matching the query criteria.
d. Click Reset to clear the query criteria and display all radios.
Enabling spectrum analysis/FFT monitoring
To scan interferences, monitor AP channel qualities, or perform other operations on a radio, first
enable spectrum analysis for the radio. To monitor, record, or save the data of FFT, FFT Duty Cycle, or
Swept Spectrogram, first you must enable FFT monitoring.
To enable spectrum analysis or FFT monitoring:
1. Click the Service tab.
2. From the navigation tree, select WLAN Manager > Spectrum Guard > Radio Config.
The Radio Config page appears.
3. Select APs for which you want to enable spectrum analysis or FFT monitoring from the Radio List.
4. Click Enable Analysis or Enable FFT.
The Result List page shows the operation result for each radio.
5. Click Back to return to the Radio Config page.