Rogue client report – H3C Technologies H3C Intelligent Management Center User Manual
Page 662
640
•
Begin Time/End Time—These two parameters appear only when you select Custom Range. Click
the field next to Begin Time/End Time to select the start time/end time from the calendar that
appears, in the format of YYYY-MM-DD hh:mm. The end time must be later than the start time.
shows an example rogue client history report.
Figure 100 Rogue client history report
Rogue client history report fields:
•
Report Period—Time range during which the statistics are collected.
•
MAC Address—MAC address of the rogue client.
•
Vendor—Vendor of the rogue client.
•
Max Signal Strength—Maximum signal strength of the rogue client.
•
Channel—Channel used by the rogue client.
•
Detected by—AC that detected the rogue client.
•
Detected AP—Fit AP that detected the rogue client.
•
Last Discovered Time—Time when the rogue client was last discovered.
•
Status—State of the rogue client, Attacked or Not Attacked.
Rogue client report
This report displays all the new rogue clients detected for the first time by MAC address.
No specific parameters are required for viewing a rogue client report.
shows an example rogue client report.
Figure 101 Rogue client report
Rogue client report fields:
•
MAC Address—MAC address of the rogue client.
•
Vendor—Vendor of the rogue client.