H3C Technologies H3C Intelligent Management Center - Manual (Page 239)

217
{
Channels in Use—Specify the working channel of the radio. The value range depends on the
radio type. If you specify Auto, a fat AP selects an idle channel as the working channel.
{
Max Transmit Power (dBm)—Enter the maximum transmit power of the radio.
{
Preamble Type—You can specify the preamble type for the fat AP if you specify the 802.11b,
802.11g, or 802.11gn radio type.. Options are:
− Short—Fat AP transmits frames with either a short preamble or long preamble.
− Long—Fat AP only transmits frames with a long preamble.
6. In the Radio List area, click Add.
The Select Device dialog box appears.
7. Enter or specify one or more of the following query criteria to search for the radios you want to
configure:
{
Device Label—Enter the label of the fat AP. WSM supports fuzzy matching for this field.
{
IP Address—Enter a partial or complete IPv4 address of the fat AP. WSM supports fuzzy
matching for this field.
{
Model—Enter the model of the fat AP. WSM supports fuzzy matching for this field.
{
Radio Type—Specify a radio type. Options are:
− 802.11a
− 802.11b
− 802.11g
− 802.11gn
− 802.11an
{
Location—Enter or specify the name of the location view to which the fat AP belongs. WSM
supports fuzzy matching for this field.
An empty field or a field that is set to Unlimited does not serve as a query criterion.
8. Click Query.
The Radio List displays all radios matching the query criteria. Click Reset to clear the query
criteria and display all radios.
NOTE:
To avoid configuration failures, HP recommends that you configure radios on fat APs of the same
model in batches.
9. Specify the radios you want to configure.
10. Click OK to close the Select Device window.
The Radio List displays all selected radios.
11. Click OK.
The Result List page appears, displaying the configuration result of each radio.
12. Click Back to go back to the radio batch configuration page.