H3C Technologies H3C Intelligent Management Center - Manual (Page 594)

572
{
Mesh Interface ID—ID of the mesh interface to be bound to the mesh profile. If you enter a
nonexistent ID, WSM automatically creates the ID on the AC. One mesh interface can be
bound to only one mesh profile.
{
Link Backhaul Rate—Backhaul rate of the mesh link. The value varies with radio types, and
must be the same in one mesh network.
{
Link Keep Alive Interval—Interval for sending keepalives, in seconds. If an AP has not
received a response from its peer AP after three attempts of sending keepalives, the mesh
link disconnects.
{
Enable Mesh Profile—Enable the mesh profile. A mesh profile can be enabled only when it
is bound to a mesh interface with port security configured.
{
Enable MKD Service—Set the AC as the MKD device for the mesh profile. It is supported on
ACs only.
7. Click OK.
Modifying a mesh profile
1. Click the Service tab.
2. From the navigation tree, select WLAN Manager > Resource Management > ACs or WLAN
Manager > Resource Management > Fat APs.
3. Click the device label of an AC or fat AP to enter the device information page.
4. On the Mesh Management menu on the lower right corner of the page, click Mesh Profile
Management.
The Mesh Profile Management page appears.
5. Click the Operation icon of the target mesh profile, and then select the Modify icon .
6. Modify the parameters for the mesh profile. Mesh Profile ID cannot be modified. For more
information about other parameters, see "
Adding a mesh profile ."
7. Click OK.
Deleting a mesh profile
If the mesh profile has been bound to a radio, it cannot be deleted. You must unbind the radio before
deleting the mesh profile. For more information about unbinding radios, see " Unbinding a mesh
profile ."
To delete a mesh profile:
1. Click the Service tab.
2. From the navigation tree, select WLAN Manager > Resource Management > ACs or WLAN
Manager > Resource Management > Fat APs.
3. Click the device label of an AC or fat AP to enter the device information page.
4. On the Mesh Management menu on the lower right corner of the page, click Mesh Profile
Management.
The Mesh Profile Management page appears.
5. Click the Operation icon , and then click the Delete icon on the menu that appears.
6. Click OK.