H3C Technologies H3C Intelligent Management Center - Manual (Page 355)

333
18 Managing AP access ports
WSM enables operators to manage AP access ports. An AP access port directly or indirectly
connects the access device to an AP. AP access port management in WSM enables operators to view
the access information for fit, fat, and rogue APs and to perform the following management functions:
• Collecting Data—Allows you to collect access data from AP access ports. Make sure the access
devices are already added to IMC.
• Managing PoE—Allows you to enable or disable the PoE function on AP access ports to perform
a cold startup or shutdown remotely on the connected AP. This function is supported only on PoE-
capable AP access ports.
• Configuring Auto Rogue AP Isolation—Allows you to start up or shut down rogue AP access
ports and to configure automatic shutdown of all uplink access ports of directly connected rogue
APs.
Managing fit AP access ports
WSM allows you to manage fit AP access ports on the AP Access Ports page.
Viewing fit AP access ports
You can view all fit AP access ports managed in WSM and information about the related fit APs,
including the status, name, SN, IP address, MAC address, access device, access interface, and
collect time.
To view fit AP access ports:
1. Click the Service tab.
2. From the navigation tree, select WLAN Manager > Resource Management > AP Access Ports.
The AP Access Ports page appears.
3. Click the Fit AP tab.
The Device List page displays all fit AP access ports and the related fit AP information.
Device List contents
{
Status—Displays the fit AP status, connectivity between the fit AP and the access device, and
the PoE status of the access device.
− The state of the fit AP can be Online/Primary, Online/Secondary, or Offline.
Online/Primary indicates that the online fit AP is connect to and managed by the master
AC. Online/Secondary indicates that the online fit AP is connected to and managed by
the backup AC.
− The Direct Link icon indicates that the fit AP is directly connected to the access device.
The Indirect Link icon indicates that the fit AP is directly or indirectly connected to the
access device.
− The PoE Enable icon indicates that the AP access port is enabled with PoE. The PoE
Disable icon indicates that the AP access port is disabled with PoE. WSM displays