H3C Technologies H3C Intelligent Management Center - Manual (Page 154)

132
6. Click OK.
Managing service policy templates
Applying an appropriate service policy template to the AC can simplify the service policy
configuration procedure because you only need to change the policy ID and interface ID.
Viewing the service policy template list
1. Click the Service tab.
2. From the navigation tree, select WLAN Manager > Configuration Management.
The Configuration Management page appears.
3. Click the Comware-Based tab.
4. In the Network Management area, click the Template Management link.
The Template Management page appears. There are two types of policy templates:
{
Radio Policy Template
{
Service Policy Template
5. Click the Service Policy Template link.
The Service Policy Template List page appears, displaying all service policy templates.
Service Policy Template List contents
{
SSID—SSID of the service policy template.
{
Encryption Mode—Encryption mode for the service policy template. Options are:
− Clear—The clients can access the wireless network without any passwords.
− Crypto—The clients must enter the correct password to access the wireless network.
{
Hide SSID—Indicates whether to provide the SSID in beacon frames sent by the fit AP. If this
parameter is selected, clients cannot obtain the SSID from the beacon frames, and must
configure the SSID before accessing the wireless network. If this parameter is not selected,
clients can obtain the SSID from the beacon frames to access the wireless network.
{
Authentication Mode—Authentication mode of the service policy template. Options are:
− Open System—Allows all clients requesting for authentication to directly pass
authentication.
− Shared Key—Requires clients to use the same shared key as that configured on the
device. Select Shared Key only when you select WEP40 or WEP104 as the cipher suite.
− All—Allows clients to use either the Open System mode or the Shared Key mode as
needed.
{
Modify—Click the Modify icon for the target service policy template to modify its
parameters. For more information, see "
Modifying a service policy template ."
{
Delete—Click the Delete icon for the target service policy template to delete the template.
For more information, see "Deleting a service policy template."
Viewing service policy template details
1. Click the Service tab.
2. From the navigation tree, select WLAN Manager > Configuration Management.
The Configuration Management page appears.