H3C Technologies H3C Intelligent Management Center - Manual (Page 670)

648
Figure 108 Busy AP statistics report
Busy AP statistics report fields:
• Report Period—Time range during which the statistics are collected.
• Location—Name of the location view for which the statistics are collected or All AP Devices.
• AP Name—Access point name.
• AP Location—Location view to which the AP belongs.
• Peak Number of Online Clients—Maximum number of clients associated with the AP.
• Peak Transmission Rate (Mb/s)—Maximum transmission rate of the AP.
• Out of Service Rate (%)—Percentage of time the AP is unavailable.
• Association Congestion Rate (%)—Association congestion rate of the AP, which is the ratio of
client association failures to the total number of association requests.
• Client Dropping Rate (%)—Client dropping rate of the AP, which is the ratio of abnormal logoffs
to the total number of clients associated with the AP.
Idle AP statistics report
This report displays statistics about the APs with the lowest total usage, including the peak online
client number, peak transmission rate, out of service rate, association congestion rate, and client
dropping rate.
To view an idle AP statistics report, configure the following parameters:
• Parameter "Begin Time and End Time"—Select a statistics collection time range from the list. You
can select a specific time range, such as Last Hour, Last Day, Last Week, or Last Month, or
select Custom Range, and then specify the start time and end time manually.
• Location—Select a specific location view for statistics collection, or select All AP Devices.
• Begin Time/End Time—These two parameters appear only when you select Custom Range. Click
the field next to Begin Time/End Time to select the start time/end time from the calendar that
appears, in the format of YYYY-MM-DD hh:mm. The end time must be later than the start time.
• Peak Number of Online Clients—Specify the peak number of online clients threshold for the AP.
An AP is considered idle when its online client number is equal to or below the specified
threshold. The default is 0. Click Save to save it as the default value.
• Peak Transmission Rate—Specify the maximum transmission rate threshold for the AP, in Mb/s.
An AP is considered idle when its transmission rate is equal to or below the specified threshold.
The default is 1 Mb/s. Click Save to save it as the default value.