H3C Technologies H3C Intelligent Management Center - Manual (Page 422)

400
{
Select one or more MSM series ACs on the list, and then click Enable IDS or Disable IDS in
the ACs list area.
{
Click the Operation icon for an MSM series AC, and then select Enable IDS or Disable
IDS from the menu.
Enabling/disabling fit APs to detect rogue APs
You can enable or disable fit APs managed by an AC to detect rogue APs.
• A Comware-based fit AP can detect rogue APs only when its work mode is set to Monitor or
Hybrid.
• An MSM series fit AP can detect rogue APs only when its monitoring status is set to Enable.
Accessing the Detect Fit AP page
1. Click the Service tab.
2. From the navigation tree, select WLAN Manager > WIDS Management > WIDS Config.
The ACs list displays all managed ACs in WSM.
3. Click the number link in the Detector column of a Comware-based AC.
The Device List displays all the fit APs managed by the AC with a work mode of Monitor or
Hybrid.
Device List content
{
Online Status—Online state of the fit AP, for online and for offline,
{
Device Status—Alarm or management state of the fit AP. Options are:
− Critical
− Major
− Minor
− Warning
− Normal
− Unknown
− Unmanaged
{
AP Label—Label of the fit AP. Click the label to view the fit AP details.
{
AP Name—Fit AP name.
{
SN—Serial number of the fit AP.
{
IP Address—IP address of the fit AP.
{
MAC Address—MAC address of the fit AP.
{
Model—Fit AP model.
{
Monitoring Status—Monitoring state of the fit AP, which is always Enable. This column is
available only for MSM series fit APs.
{
Work Mode—Work mode of the fit AP, which is always Hybrid or Monitor. This column is
available only for Comware-based fit APs.
{
AC—Device label of the AC that manages the fit AP. Click the label to view the AC details.
If the Device List contains enough entries, the following navigational aids are displayed: