Metrohm 746 VA Trace Analyzer - Manual (Page 514)

7.3 Error messages
746 VA Trace Analyzer / 747 VA Stand
7-15
Error message Meaning/Causes Rectification Exit
EVAL - ERROR 7:
AC2: illegal baseline
scope With measurement mode
AC2MODE , only whole is
allowed for Scope
Set Scope to whole E/C
EVAL - ERROR 8:
AC2: illegal baseline
type With measurement mode
AC2MODE , selection of polynom
or expon. for the baseline
type is not admissible
Set baseline type to AC2 rel. , AC2
abs. or linear (identical to AC2
abs. )
E/C
EVAL - ERROR 9:
Wave: illegal baseline
scope In the measurement mode
DCTMODE , only whole is
admissible for Scope
Set Scope to whole E/W
GRAPHICS - ERROR 1:
Display sector too
small The selected display range is
too small
Expand display range (change dis-
play/plot parameters)
E/C
KEYBOARD - ERROR 1:
Keyboard hardware
defect Keypad hardware faulty − Press Reset key
− If error reappears, inform Metrohm
service
S
KEYBOARD - ERROR 2:
HSA is ON, RS module
has not set HSA off Handshake error in the RS232
module
− Press Reset key
− If error reappears, inform Metrohm
service
S
KEYBOARD - ERROR 3:
HSB is ON before data
is set Handshake error in the RS232
module
− Press Reset key
− If error reappears, inform Metrohm
service
S
KEYBOARD - ERROR 4:
HSA and HSB are ON
before data is set Handshake error in the RS232
module
− Press Reset key
− If error reappears, inform Metrohm
service
S
KEYBOARD - ERROR 5:
CNT is ON in spite of
write cycle Handshake error in the RS232
module
− Press Reset key
− If error reappears, inform Metrohm
service
S
KEYBOARD - ERROR 6:
CNT is not ON in spite
of read cycle Handshake error in the RS232
module
− Press Reset key
− If error reappears, inform Metrohm
service
S
KEYBOARD - ERROR 7:
HSB is not set to ON at
read cycle Handshake error in the RS232
module
− Press Reset key
− If error reappears, inform Metrohm
service
S
KEYBOARD - ERROR 8:
HSA is not set to OFF
at read cycle Handshake error in the RS232
module
− Press Reset key
− If error reappears, inform Metrohm
service
S
KEYBOARD - ERROR 9:
HSB is not set to OFF
at read cycle Handshake error in the RS232
module
− Press Reset key
− If error reappears, inform Metrohm
service
S
KEYBOARD - ERROR 10:
HSA + HSB are not set
to OFF at read cycle Handshake error in the RS232
module
− Press Reset key
− If error reappears, inform Metrohm
service
S
KEYBOARD - ERROR 11:
Keyboard interface,
data not equal Initializing error − Press Reset key
− If error reappears, inform Metrohm
service
S
KEYBOARD - ERROR 12:
EOS is not set to ON
after configuration Initializing error − Press Reset key
− If error reappears, inform Metrohm
service
S
KEYBOARD - ERROR 13:
HSA is not set to OFF
after write cycle Handshake error in the RS232
module
− Press Reset key
− If error reappears, inform Metrohm
service
S
KEYBOARD - ERROR 14:
Unknown keyboard error Non-specified keypad error − Press Reset key
− If error reappears, inform Metrohm
service
S