Metrohm 746 VA Trace Analyzer - Manual (Page 384)

5.7.3 Alphabetical instruction list
746 VA Trace Analyzer / 747 VA Stand
5-233
Description The DSWEEP instruction (Dummy Sweep) starts the voltage sweep
defined in the parameters. While measured values are recorded during
the sweep, they are not stored.
U
t
U.start
U.end
U.step
t.step
Comments • The electrode type must be defined before the DSWEEP instruction.
Admissible are DME , SMDE , HMDE or RDE .
• The measurement mode must be defined before the DSWEEP
instruction. Admissible are DCTMODE , DPMODE , AC1MODE , AC2MODE or
SQWMODE , but not PSAMODE or CYCMODE .
• With the DSWEEP instruction, the potentiostat always operates in the
operating mode "fast".
• If the final voltage U.end should not be switched off at the end of the
program, enter a suitable standby voltage U.standby in a ØMEAS
instruction.
see also SWEEP, FSWEEP, SSWEEP, DME, SMDE, HMDE, RDE, DCTMODE,
DPMODE, AC1MODE, AC2MODE, SQWMODE