Metrohm 746 VA Trace Analyzer - Manual (Page 264)

5.5.3 CURVES
746 VA Trace Analyzer / 747 VA Stand
5-113
Softkeys Meaning
Uppr/lft
corner
Once the top left corner point is in the desired position, it must be
fixed by pressing the softkey
or the
key. Next, the bottom right corner point of the zoom region is also
defined using the cursor keys. This automatically opens a frame
encompassing the region to be enlarged.
Lwr/rght
corner
Once the bottom right corner point is in the desired position, it must
be fixed by pressing the softkey
or the
key. Next, the selected zoom region is shown full screen
and the parameters in the display/plot window updated appropriately.
These changes are temporary, they are canceled with
param.> or after exit with .
The changes in the display/plot parameters are permanently incorpo-
rated in the method only if they are stored with
before
exiting.
The procedure described for selection of the zoom region can be
repeated several times in succession.
New
display
Redisplay curve
This softkey is used for manual initiation of a recalculation and curve
display (this normally runs automatically each time the parameter
modification is closed).
Reset
param.
Reset display/plot parameters
The parameters appearing in the window are reset to the values
entered on the "SEGMENTS" page.
Save
param.
Store display/plot parameters
The parameters appearing in the window are transferred to the
"SEGMENTS" page and hence stored in the method.