Metrohm 746 VA Trace Analyzer - Manual (Page 251)

5.5 Operation
746 VA Trace Analyzer / 747 VA Stand
5-100
Parameter Range; Default value / Meaning
I.peak display only
Peak height
Determined peak height in A.
I.peak is shown for curves recorded with one of the following meas-
urement modes:
DPMODE, SQWMODE, AC1MODE
DCTMODE with SSWEEP (peaks)
CYCMODE with only 1 ramp
I
U
I.peak
I.wave display only
Wave height
Determined wave height in A.
I.wave is shown for curves recorded with one of the following meas-
urement mode DCTMODE and SWEEP (for waves).
I.wave
I
U
I.abs, I.rel display only
Current evaluation quantity for AC2 curves
Determined current evaluation quantity in A.
I.abs or I.rel is shown for curves recorded with the measurement
mode AC2MODE.
I.abs
Type = AC2 abs.
I
f
I
r
I.rel = I
f
+ I
r
I
U
Type = AC2 rel.
I
U
P.peak display only
Peak area
Determined peak area in W.
P.peak is shown for curves recorded with one of the following meas-
urement modes:
DPMODE, SQWMODE, AC1MODE
DCTMODE with SSWEEP (peaks)
CYCMODE with only 1 ramp
In an evaluation with Scope = f.half or Scope = r.half , the area up
to the peak maximum is shown here.