Metrohm 746 VA Trace Analyzer User Manual
Page 223
5.5 Operation
746 VA Trace Analyzer / 747 VA Stand
5-72
Measurement window
During an ongoing measurement, the measurement window is shown with the following
current data:
Status
Meaning
* READY *
Ready
The instrument is in the standby mode, all dialog pages can be
selected. A new measurement or measurement series (with
Auto.batch = on
) must be started with the
* BUSY *
Program running
The program loaded in the working memory that has been started with
the
Auto.batch = on
) is running.
In this instrument mode, the following limitations apply to the screen
dialog:
•
The two dialog pages "STAND" and "CURVES" can not be se-
lected.
•
The entry of sample data in the 1
st
input line of the
"MONITORING" page is not possible (see section 5.5.1). With
programs for the 695 Autosampler with preparation cycles, this
also applies to the 2
nd
input line.
•
Changes to the program loaded in the working memory
("OP.SEQUENCE" or "SEGMENTS") or to any parameters on the
other dialog pages are immediately effective for the current de-
termination. However, care should be exercised when making
such changes as uncontrolled program status conditions could
easily be produced.
During the measurement, either the measurement window (see
above) or, after switching with the softkey
, the current
experimental curve is shown.
In the instrument status
* BUSY *
, the following main function keys
are active (for details, see section 5.1.4):
Active program aborted immediately
ongoing determination
Abbreviation of the current instruction
Exception: SWEEP instructions can not be
abbreviated with the
ever, it is possible to change the SWEEP
parameter
U.end
at any time.
The program is interrupted
Segment: XXXXXXXX XX XXXXXXXXXXXXX XXXX s
VR: XX
U = XXXXX V
I = XXXXXXXXX A
Program line with line
number, program
instruction and line time
Measured values,
voltage (U) and
current (I)
Segment name
Variation (V)
Replication (R)